SRS Light Design s.r.o
, Rybničná 36/D , 831 06 Bratislava, Slovak Republic
tel:+421244681417, fax:+421244681419,
www.srslight.com
,
DIN rail holder:
DIN rail terminals are located on the rear side of DST8-DIN splitter.
C-clamp + Securing point:
DST8-DIN splitter is also equipped with M10x20 point for C-clamp and Securing eye connection point. These
points are located on the right side of the device. C-clamp is not included in the device.
Device in use:
By default, Power LED indicates the device is on main power. If there is no power light present, please
check the main power input. If the DMX cable is connected to the device, LEDs marked as D+ and D- go on
for side marked as DMX input, thru and this indicates that DST8 is receiving the DMX signal. Speed of light
on these LEDs also indicates the refresh rate of DMX signal. Fast blinking – high refresh rate, slow blinking –
slow refresh rate.
There are 8 optically isolated outputs that retransmit the DMX input signal. If any of data LEDs is off, unplug
the signal cable corresponding to this output and check the cable for short circuit between D+ and CMN or
D- and CMD lines.
Should there be any problem, please do not hesitate and contact us at
or
+421244681417 and stay calm. SRS Light Design will certainly help you fix all the problems.
