SRS Light Design s.r.o
, Rybničná 36/D , 831 06 Bratislava, Slovak Republic
tel:+421244681417, fax:+421244681419,
www.srslight.com
,
DMX operation
For the DMX operation, turn off the W-DMX
module by holding the MODE button until
both W-DMX and MODE buttons light in red
color.
Connect the DMX cable to the DMX-in
connector and use DST4W as a standard
DMX isolated one-to-four splitter.
W-DMX operation
For the W-DMX operation, turn on the W-
DMX module by holding the MODE button
until it lights in green color.
The W-DMX function button will indicate the
W-DMX functionality as shown on the
bottom of this page.
To log off from a linked transmitter, hold
the W-DMX Button for more than 5 sec.
There is an automatic backup of the W-DMX line by a cable connection. When
DST4W unit is linked to the transmitter and the signal quality is poor, W-DMX active
LED goes off and splitter retransmits signal from the cable DMX in/thru port.
In the normal state of good signal quality, the W-DMX active LED is on.
W-DMX LED/button signalization:
