SR
SYSTEM-ELEKTRONIK GmbH
|
Eschachstr. 23
|
D-78078 Niedereschach
|
phone +49 77289268-0
|
Seite | 12
Auto signal detection
This function automatically detects the connected video input signal . The
monitor has a VGA input/DVI and optional display port or HDMI input. The
controller starts with VGA, then DVI, HDMI, DP. If the signals become active
later, the portscan be within the search sequence. No priority is set here, first
signal detected ! it stays until it becomes inactive. Only after that the portscan is
done again. If no signal is connected or the video signal is lost (connection is
disconnected), the monitor behaves as described under VESA - DPM S. This mode
can only be restored by turning the power off. As long as the monitor is not
switched to the power suspend mode, the last detected video source returns
when the monitor is switched on again (image is displayed again).
Characteristics
Supports PC signals from 640x480 to 1920x1200 (depending on LCD display) with 60 Hz V-
Sync.
DOS, VGA, SVGA, XGA, WUXGA, SXGA, UXGA (abhängig von der Panel-Spec.)
H-Sync: 30 KHz ~ 80 kHz
V Sync: 56 Hz~ 75 Hz
VESA- mounting
Mounting screws M4 x 75 mm (length = max. 10 mm!); M8 for larger devices.
Environmental conditions
Operating temperature:
0° to +50° C
Storage temperature:
-20° to +60° C
Humidity:
85% (non-condensing)
