10
Rear Hub Bearing Removal
Install the 17 mm bearing puller slotted attachment through the non-
drive side bearing. Align the slotted attachment with the bottom of
the bearing, then tighten the slotted attachment to expand the puller
inside the bearing.
N OT I C E
Do not overtighten the slotted attachment. For more detailed assembly
and usage information, consult your bearing puller
manufacturer's
instructions.
Thread the shaft of the bearing puller into the slotted attachment. Hold
the wheel firmly in place and forcefully pull back on the slide hammer
to remove the bearing from the non-drive side of the hub shell.
Remove the bearing from the slotted attachment.
Spray isopropyl alcohol on the rear hub bearing bores and the axle,
and clean them with a rag.
4
17 mm Bearing puller slotted attachment
Bearing puller
5
6
Rear Hub Bearing Removal
Rear Hub Bearing Removal
