35
Lower Leg Installation
L o w e r L e g I n s t a l l a t i o n
Clean the upper tube.
Clamp the spring side upper tube into the work stand angled slightly
Clamp the spring side upper tube into the work stand angled slightly
upward.
upward.
Install the spring side lower leg onto the upper tube and slide it just
Install the spring side lower leg onto the upper tube and slide it just
enough to engage the upper bushing.
enough to engage the upper bushing.
NOTICE
Make sure the wiper seal slides onto the tube without folding the
outer lip of the seal.
The inside bottom of the lower leg should not contact the spring shaft.
The inside bottom of the lower leg should not contact the spring shaft.
A gap between the shaft end and the lower leg bolt hole should
A gap between the shaft end and the lower leg bolt hole should
be visible.
be visible.
1
2
Spring Side
3
