24
RS Lever Blade Installation
R S L e v e r B l a d e I n s t a l l a t i o n
Use needle nose pliers to install the SwingLink™ bushings.
If the SwingLink bushings fall out easily, apply a small amount of DOT
grease to the bushings to help hold them in place.
Insert the lever blade bushings into both sides of the lever.
Place the pushrod into the piston.
Line up the hole in the SwingLink with the hole in the bushings, then
push the pivot pin into the hole until it stops.
1 1
Needle nose pliers
2.7-3.2 N•m (24-28 in-lb)
22 mm
2
3
4