Model SR7020
i
Wall Mount Platform Scale
Operating and Service Manual
Part No.MAN7020I_MICROBAN_200520
Page 5 of 16
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
email:
S
Instruments, Inc.
INSTALLATION (CON’T)
STEP 6:
For stud wall mounting locations without a stud, use a screwdriver to drive the provided self-
drilling wall anchors into the wall. It is not recommended to use a power drill to set the wall anchors.
For concrete wall mounting, install appropriate wall anchors at all marked screw locations.
STEP 7:
Mount the bracket to the wall by either using the provided #8 x 1” Phillips flat head screws into
the self-drilling wall anchors or using the customer supplied appropriate flat head screws long enough to
anchor into the wall or the concrete anchors.
NOTE
: The screws need to be a flat head type screw so there is adequate clearance for the scale frame to
slide into the wall bracket.
STEP 8:
After the bracket is securely fastened to the wall, have two people lift the SR7020i Series scale
and place it into the wall mounting bracket.
INSTALLATION (CON’T)
STEP 9:
Carefully lower the SR7020i Series platform down into position for use and plug the provided AC
power cord into the power supply located inside the bracket at the right end of the upper support bar and
into a wall outlet (Figure 3
)
.
Figure 3: Power Cord Plug In
IMPORTANT
THE WALL BRACKET IS INTENDED TO KEEP THE SCALE
FROM PULLING OFF OF THE WALL. ENSURE THAT THE
ENTIRE WEIGHT OF THE SCALE IS ON THE FLOOR AND
NOT ON THE WALL BRACKET.
WARNING
THE COUNTER BALANCE
ACTUATORS ASSIST THE END USER
WHEN RAISING OR LOWERING THE
PLATFORM. THE END USER NEEDS
TO CONTROL THE RAISING AND
LOWERING OF THE PLATFORM.
