Manual | Aura Panel gold matrix & dream color
Fixture Time
Press the
MENU
button up to when the Fixture Time is blinking on the display. Pressing
ENTER
button and the
display will show the number of working hours of the unit.
To go back to the functions press the
MENU
button again. Hold and press the
MENU
button about one second or
wait for one minute to exit the menu mode.
Firmware Version
Press the
MENU
button up to when the Firmware version is blinking on the display. Pressing
ENTER
button and
the display will show the version of software of the unit. To go back to the functions press the
MENU
button
again. Hold and press the
MENU
button about one second or wait for one minute to exit the menu mode.
5. How To Control The Unit
You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will be affected
at once. Each time you turn the unit on, it will show “M336” on the display. After that the unit will be ready to
receive DMX signal or run the built in programs.
5.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give an automatic,
sound activated, synchronized light show. This function is good when you want an instant show. You have to set
the first unit in master mode and select show 0 (random show ), show 1 or …or show 8. Its DMX input jack will
have nothing plugged into it, and Its master LED will be constantly on and sound LED will flash to the music.
5.2 DMX Controller
Using universal
DMX controller
to control the units, you have to set DMX address from 1 to 512 channel so that
the units can receive DMX signal.
Press the
MENU
button up to when the DMX Address is showing on the display. Pressing
ENTER
button and the
display will blink. Use
DOWN
and
UP
button to change the DMX512 address.
Once the address has been selected, press and keep
ENTER
button pressed up to when the display stops blinking
or storing automatically 8 seconds later. To go back to the functions without any change press the MENU button
again. If you use please refer to the following diagram to address your DMX512 channel for the first 4 /2 units.
