Manual | Aura Bar & Matrix Beam Light 100
1. SAFETY INSTRUCTIONS
Please read these instructions carefully
they include the important information
about the installation usage and
maintenance of this products
• Please keep this User Manual for future consultation. If you sell the fixture to another user, be sure that
they also receive this instruction booklet.
• Unpack and check carefully there is no transportation damage before using the fixture.
• It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.
• Disconnect main power before servicing and maintenance.
• The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces.
Be sure that no ventilation slots are blocked.
• Maximum ambient temperature is Ta : 40°C. Don’t operate it where the temperature is higher than this.
• Unit surface temperature may reach up to 85°C. Don’t touch the housing bare-hand during its operation.
Turn off the power and allow about 15 minutes for the unit to cool down before replacing or serving.
• In the event of serious operating problem, stop using the fixture immediately. Never try to repair the
fixture by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center. Always use the same type spare parts.
• Do not connect the device to any dimmer pack.
• Do not touch any wire during operation and there might be a hazard of electric shock.
• To prevent or reduce the risk of electrical shock or fire, do not expose the fixture to rain or moisture.
• The housing must be replaced if they are visibly damaged.
• Do not look directly at the LED light beam while the fixture is on.
• There are no user serviceable parts inside the fixture. Do not open the housing or attempt any repairs by
yourself. In the unlikely event your fixture may require service, please contact your nearest dealer.
• Due to the magnifying type lens, please keep the lens out of contact with direct sunlight. Direct sunlight
can cause heat to build up inside of the unit, which will seriously damage unit.
