Square Scrub EBG-20, Owner'S Manual

Page: 6 / 9

runs erratically Low voltage from excessive length Use 12 gauge extension cord
or undersized extension cord not more than 25’ long
Defective start switch Contact Square Scrub dealer
Defective motor low voltage Contact Square Scrub dealer
Fuse/ Circuit Breaker trips Low voltage Allow the motor to cool. The
circuit breaker is a red button
on the side of the motor that
will reset when pressed.
Eliminate extension cord.
Locate power cord closer to work site. Have voltage checked by electrician.
Machine pulls hard to one side Rubber isolators worn out Replace isolators.
NOTE: The rubber isolators on the EBG ‐ 20 Floor Preparation Machine are considered wear items. It is
recommended to replace the entire set of all four isolators at least every 100 hours of machine opera ‐
tion to prevent failure and damage to the machine.
Machine is noticeably louder than it was when new Replace isolators.
Square Scrub, Inc.
www.squarescrub.com
Toll free 800 ‐ 577 ‐ 6822