4
1. First, open the case and remove all of the components. Then
remove the components from their boxes and bags. Verify that you
have all the parts listed on page 3.
2. Assembling the Softboxes
A. Open up one of the softbox
bodies (J) and slip the body
over the light body (B) so that
the silver reflective side is facing the direction of the light
sockets (Figure 1).
B. Ensure that the orientation of the softbox is such that the
two hook and loop tabs are right or left with respect to
the light body (Figure 2).
C. Insert a tension
support flex rod (E)
into one of the
corners opposite a
hook & loop tab
(Figure 3). There will
be a cup sewn into
the corner that the
white plastic tip will
fit into.
D. Insert the other end of the tension support flex rod (E)
into the appropriate hole in the light body (B) to maintain
the orientation shown in Figure 2. (See Figure 3).
Repeat for second rod on the same side.
E. Now place the uncapped ends of the 3rd and 4th tension
support rods into the light
body opposite the first two,
so that they angle out to
meet the hook & loop
tabs. Stretch the softbox
body outward until you
can secure the end of the
tension rod with the hook
& loop fastener (Figure 4).
Repeat for the other
tension rod.
F. Now screw 5 light bulbs (G) into the light body (B)
(Figure 5).
Copyright 2012 DTX International
SP2 CONTINUOUS LIGHT KIT SETUP
Figure 1
Figure 3
Figure 4
Figure 5
Figure 6
Figure 2
