1. Extend the antenna to its maximum length.
2. Move the power switch to end position. The blue power indicator near the power switch will light
up.
3. Turn the RF signal sensitivity dial up to the highest setting, then slowly turn it down until only one
of the four indicator LEDs remains on. If any RF signals are detected, one or more of the RF
signal indicators will light up. The more RF signal indicators that are lit, the stronger the signal
and the buzzer pitch will get louder.
4. Gradually shorten the length of the antenna and adjust the RF signal sensitivity dial to reduce the
detection range. This will let you hone in on the source of the signal.
Some hidden cameras record video to an internal memory card that is meant to be retrieved later,
so trying to detect a radio wave from the camera will be pointless. Therefore, you’ll also want to
deploy the The Debugger’s light beam detection method.
To Detect a Non-Transmitting Camera
Vibration Mode
1. Insert the included earphones into the earphone jack located on the top of the unit.
2. Extend the antenna to its maximum length.
3. Turn the RF signal sensitivity dial up to the highest setting, then slowly turn it down until only one
of the four indicator LEDs remains on. If any RF signals are detected, one or more of the RF
signal indicators will light up. The more RF signal indicators that are lit, the stronger the signal
and the buzzer pitch will get louder.
4. Gradually shorten the length of the antenna and adjust the RF signal sensitivity dial to reduce the
detection range. This will let you hone in on the source of the signal.
Silent Mode
This allows you to keep track of the direction you’re standing as you walk around the room and aim
the unit.
Magnetic Compass
xb-68 rf detector & camera finder user guide
4
