When the pump is used as bilge pump
Max total head 6 m. The pump must be installed so that the motor is protected from splash
from bilge water.
The pump must be fitted with a strainer or other means of preventing debris from entering the
pump.
Freezing weather
Drain unit by loosening the endcover. Glycol based anti-freezes can be used but do not use
petroleum based anti-freeze compounds.
Waste handling/material recycling
At the product’s end of life please dispose of the product according to applicable law. Where
applicable please disassemble the product and recycle the parts material.
Service instructions F2P10 (see page 42)
Disassembly
1. Back off the endcover screws (7) and remove the endcover (5) and O-ring (6).
2. Pull out the impeller (3) using a slip joint plier or other suitable implements.
3. Remove the wearplate (7).
4. Remove the nuts (8) holding the pump body to the motor and remove the pump
body from the motor.
5. Remove the lip seal (4).
6. Do not disassemble the motor.
Assembly
1. Moisten the new lip seal with soapy water (5 % soap) and mount the seal with the lip
facing towards the impeller.
2. Lubricate the motor shaft with Vaseline of the like.
3. Assemble the wearplate.
4. Lubricate inside the pump body where the impeller should be placed with Johnson
Pump impeller lubricant 09-47086, glycerine or similar. Also lubricate the surface of the
endcover.
5. Fit in the impeller with a rotating movement in the intended direction of the pump rotation.
6. Lubricate the O-ring with Johnson Pump impeller lubricant 09-47086, glycerine or similar.
Position the O-ring and fasten the endcover.
Service instructions F3B-19 / F3B-19 Oil Change / F38B-19 / F4B-19
(see page 43-46)
Disassembly
1. Back off the endcover screws (7), remove the endcover (5) and O-ring (6).
2. Pull out the impeller (3) using a slip joint plier.
3. Back off and remove the nuts (8) and washers (9) holding the body. Separate the body
from the motor.
4. Remove the lip seal (4).
5. Do not disassemble the motor.
13
Original instructions
> English
Summary of Contents for FLOW F2P10-19
Page 47: ...47...
