SPX FLOW S280 M-14, Manual, Page: 89 / 93

Paraflow Plate Heat Exchanger
Instruction Manual
Issue 5 Section 7.0
June 13, 2008 Page 33 of 36
Attachment of EasyClip Gaskets
Non-glued Easyclip gaskets are an alternative to glued
in gaskets that greatly simplifies on site regasketing.
During fixing the gasket a pressure is applied, which
expands 2 tongues into 2 slots in the plate. This
barbed effect (fish hook) secures the gasket to the
plate, in fact it now takes more force to remove the
gasket than to apply it. These tongues fit into
corresponding slots located around the periphery of
the plate and port areas, securing the gasket to the
plate
(Figure 27) . When the plate heat exchanger is
tightened, a complete and secure seal is assured.
To attach an EasyClip gasket, the gasket is laid out on
the plate in its correct position. The projections are
firmly pressed into the corresponding slots in the
plates. After installing the gasket, the plate may be
immediately installed in the frame in preparation for
tightening.
Figure 27
Figure 27.1
Figure 27.3
Figure 27.2
Kemper County MM218132 Approved