SPT WA-9020E, Instruction Manual

Page: 4 / 8

Operation - Electronic Control Models
Control Panel
1. Automatic mode indicator
2. Cooling mode indicator
3. Fan mode indicator
4.
5
Compressor operation indicator
6
. ‘Set temperature’ indicator
7
. ‘Room temperature’ indicator
8.
Timer operation indicator
9.
Low ventilation indicator
10.
High ventilation indicator
11.
ON/OFF (power) button
12.
Speed (ventilation) button
13.
Timer button
14.
Receiver for Remote Control
15.
‘Temperature Down’ button
16.
‘Temperature Up’ button
17.
Display window
Mode (function) option button
Turning ON/OFF
Press the ON/OFF selector; the unit will start to work at its last setting.
Setting Mode/Function
e green indicator illustrating your selected mode lights up. It is recommended to select Cooling and set
your desired temperature, as the Auto mode has a preset temperature (please see below) that cannot be changed.
The indicators of the functions in progress come on at the same time, e.g. Cool and Lo = Cooling mode with Low fan speed.
Auto Mode
When this mode is selected, the unit is preset to the following temperature settings and unit will only start to:
• Cool when room temperature is higher than 75°F
If room temperature is between 68°F and 75°F, unit will stay in Fan mode. Again, when in Auto Mode, the temperature settings cannot be
changed.
Setting the Temperature in Coolin Mode
The display window’s default is to display the ambient room temperature. The green indicator light under RT is on.
(RT = Room Temperature)
To set your desired temperature, press the Temperature Up or Down buttons (ranging from 6 °F to 90°F). Each press will increase or
decrease your set temperature by 1°F. When pressing the temperature up or down buttons, the window will change to display your set
temperature. At this time, the green indicator will light under ST (Set Temperature). Once the temperature up or down buttons is released,
the window will return to displaying the ambient temperature after a second.
Note:
When unit is in the following modes: Auto, Cool the compressor will cool the room to reach the set temperature. Once the
ient temperature has reached the set temperature, the compressor will stop and unit will run in Fan mode. To conserve energy, the
compressor will not start immediately after a couple degrees increase or decrease,
In Cooling Mode with a set temperature of 70°F
When compressor first stops after reaching 70°F, unit will auto-switch to Fan.
Compressor will start cooling again when ambient temperature increases to 7
or above.
In Auto Mode (with preset temperature of 75°F for cool)
Compressor will start cooling again when ambient temperature reaches above 80°F
7
1°F
2
.
T h
4
Mounting the unit
This unit is a portable air conditioner. It can be moved from room to room so that the cooling
can follow you anywhere. Fitting the exhaust hose is easy, through a window or wall.
Please refer to either of the following ways:
1. Using the foam strips
Installation
• Connect the supplied foam strips with the exhaust pipe, let the hot air flow to the outside.
• Should the foam strip(s) be too large, cut off the extra part to fit the window.
2. Using the Through the Wall
• Make a hole (5" in diameter) in the wall to fit the supplied round connector.
• Fit the hose directly to the round connector.
• When the hole is not in use, use the cap for the round connector to cover the hole.
g