`
9
6
6
Operation - Electronic Control Models
Mounting the unit
This unit is a portable air conditioner. It can be moved from room to room so that the cooling
can follow you anywhere. Fitting the exhaust hose is easy, through a window or wall.
Please refer to either of the following ways:
1. Using the foam strips
Installation
Setting The Fan Speed
Press the SPEED button to choose the fan speed you require, high or low.
The indicator of high or low fan will light up at the same time.
If the unit is in AUTO mode, it will select the fan speed automatically according to the
ambient temperature (the related indicators, cool, fan or heat will light up), at this time the
fan speed switch is invalid.
Setting the Timer
Press the TIMER button to set the operating hours you desire (1 to 12 hours, the timer
indicator will light up). When the set time has elapsed, the machine will turn off
automatically. The display window will show the hour(s) you set as you press the TIMER
button. If the timer button is not pressed, the unit will work continuously.
By pressing the timer button but without turning on the unit, you
can PRE-SET the time for the machine to work. For example, if you
press the timer to ‘2’, the unit will come on automatically after 2 hours.
All the above functions can also be performed with the supplied remote
control. This remote control requires 2 AAA batteries to operate.
Regulating the airflow direction
Turn the roller on the air vent to control the
airflow direction from the vertical louvers.
• Connect the supplied foam strips with the exhaust pipe, let the hot air flow to the outside.
• Should the foam strip(s) be too large, cut off the extra part to fit the window.
2. Using the Through the Wall
Connection
Notice!
• To prolong the unit’s life, it will start 3 minutes after the unit was switched on. After switching
off, please wait at least 3 minutes before switching it on again.
• The cooling system will switch off if the room temperature is lower than set. The fan,
however, keeps working at the set level. If the ambient temperature rises above the chosen
tempe5˚F, the cooling will resume.
• In heating mode, the compressor will switch off if the room temperature is HIGHER than the
set one (The fan would also be turned off with compressor in the heat mode). As the room
temperature drops below the selected level –5˚F, the heating will resume.
• This machine is equipped with an ANTI-FROST function. While using the heating function
during low temperatures, sometimes the heating will stop for a while in order to melt the
internal frost. When this occurs just wait for heating to resume.
• As you switch on the heating, the fan will stop for 15-20 seconds first for warm up purposes.
• Make a hole (5" in diameter) in the wall to fit the supplied round connector.
• Fit the hose directly to the round connector.
• When the hole is not in use, use the cap for the round connector to cover the hole.
