3
OPERATING INSTRUCTIONS
•
Place unit on a smooth level surface that can support the unit when filled with water.
•
Lift and remove mist nozzle.
•
Remove water tank. Turn it upside-don and turn the cap counter-clockwise to open.
•
Fill with COOL tap water or DISTILLED water. DO NOT USE HOT WATER.
Do not add fragrance or
oil in the water – it will cause malfunction of the unit!
•
Replace the fill cap by turning clockwise – do not over tighten.
NOTE:
When carrying a filled water tank,place one hand under for support.
•
Place water tank back on the base,be sure tank is correctly aligned with base;replace the mist nozzle.
•
Allow water to fill the reservoir in the base.
•
Plug in power source and press the Power button – the power on indicator will illuminate (Green).
•
To adjust mist intensity,turn the control knob clockwise to increase and counter – clockwise to
decrease.
NOTE:
•
If the Red indicator light illuminates after powering on,either the unit is out of water or tank is not
properly aligned.
•
Turn the mist nozzle away from walls and furniture.
•
Once the water tank is in place,do not attempt to move the humidifier.If it has to be moved,unplug the
unit and drain water from the base before moving.
•
Once the unit is plugged in or during operation,do not attempt to pick up the water tank.
•
Pay attention to the water level – add water when low (Red indicator light illuminates when water is
out.)
•
TROUBLESHOOTING
Unit is not producing mist.
•
Check if unit is powered on.
•
Turn the mist intensity level higher (clockwise)
•
Check if water is in the tank.
•
If there is water in the tank, the water level in the base may be too full. Unplug the unit, remove tank
and empty the water in the base.
•
Check if water tank is properly aligned in place.
