10
Never use a spray cleaner to clean the door pane l for it could damage the d oor lock and electrical components.
It is not allowed to use the abrasive agen t or some paper towel because of the risk of scratching or leaving spots
on the stainless steel surface.
To clean the edge around the door, you should use only a soft warm, damp rag.
To prevent penetration of water into the door lock and electrical compon ents,
do not use a spray cleaner of any kind.
Also, never use abrasive cleaners or scouring pads on the outer surfaces because
they will scratch the finish. Some papers towels can also scratch or leave marks
on the surface.
After every wash, turn off the water supply to the
appliance and leave the door slightly ajar so that
moisture and odors are not trapped inside.
Before cleaning or performing mainten ance, always
remove th e plug from the socket. Do not run risks.
To cle an the e xterior a nd rubber p arts of the dishwasher,
do not use solvents or abrasive cle aning products.
Rather, use only a cloth a nd warm soapy water.
To remove spots o r st ains from the surface of the
interior, use a clo th da mp ened with water and a little
white vinegar, or a cleaning product made spe cifically
for di shwashe rs.
When yo u go on holiday, it is reco mmened that you
run a wash cycle with the dishwasher emp ty and then
remove the p lug from the socket, turn off the water
sup ply and leave the door of the appliance slightly ajar.
This will help the seals last longer and pre vent odors
from forming within the appliance.
If the appliance must be moved, try to keep it in the
vertical position. If absolutely necessary, it can be
positioned on its back.
One of the factors that cause odors to form in the
dishwasher is food th at remai ns trapp ed in the seals.
Peri odic cleaning with a damp sponge will prevent this
from occurring.
This dishwasher is designed for operation on an adequately wire d individual 110V,60Hz.Use required fuse 15 amps.
Fused electrical supply is required-copper wire only. Time delay fuse or circuit breaker recommended and provide
separate circuit serving only this ap pliance. Outlet should be placed in adjacent cabinet.
After making sure that the voltage and the freque ncy valu es for the current in the h ome
correspond to those on the rating plate and that the electrical system is sized tor the maximum
voltage on the rating plate, insert the plug into an electrical socket which is earthed properly.
If the electrical socket to which the appliance must be connected is no t appropriate tor the plug,
replace the socket, rather than using a adaptors or the like as they could cause overheating
and burns.
