5
(615) 599-1505 www.springtree.net
Installation
Power Supply
Before plugging your unit in, be sure the source voltage in your area matches the voltage
required for your lighting setup. Because line voltage may vary from venue to venue, you
should be sure your unit voltage matches the wall outlet voltage before attempting to operate
your unit.
* Always connect this product to a protected circuit with an appropriate electrical ground to avoid the risk
of electrocution or fire.
*To eliminate unnecessary wear and improve its lifespan, during periods of nonuse completely
disconnect the product from power via breaker or by unplugging it.
Mounting
The Spatial Wash COB RGBW may be mounted in any position, provided there is adequate
room for ventilation around it.
Operating in an insufficiently ventilated room can lead to an
overheating of the device and may cause serious accidents. Keep a minimum distance of
0.5m around and above the device. Do not operate this device with the top part of the
housing opened. Before deciding on a location, always make sure that it will be easy to ac-
cess the unit for maintenance and programming purposes. Make sure that the structure onto
which you are mounting this product can support its weight. Please see the
Technical Spec-
ifications
section of this manual for weight information. When mounting this product over
head, always use a safety cable. Mount the fixture securely to a rigging point, whether an
elevated platform or a truss.
Rigging
When rigging this product onto a truss, you should use a mounting clamp of appropriate
weight capacity. The bracket has a 13 mm hole, which is appropriate for this purpose.
When power linking multiple fixtures, you must always consider the length of the power
linking cable and mount the fixtures close enough for the cable to reach them.
The bracket knobs allow for directional adjustment when aiming the fixture to the desired
angle. Only loosen or tighten the bracket knobs using your bare hands. Using tools
could damage the knobs. The double bracket yoke/mounting brackets/feet also serve as floor
support(s) or surface mounting.