98-01087-ENUS R5 English-US
© TeeJet Technologies 2014
www.teejet.com
INSTALLATION
Specifications
Measuring Data
801 Flow Meter
802 Flow Meter
Linearity at recommended flow range
+/- 3.0%
+/- 3.0%
Flow Range
2-60 GPM (7.5-225 LPM)
(3-30 GPM recommended for max life)
3-130 GPM (10-495 LPM)
(5-110 GPM recommended for max life)
Maximum Working Pressure
300 PSI (20.7 Bar)
200 PSI (14 Bar)
Pressure Drop
10 GPM (37.85 LPM) - NA
20 GPM (75.71 LPM) - 3 PSI (0.21 Bar)
30 GPM (113.56 LPM) - 7.5 PSI (0.52 Bar)
40 GPM (151.42 LPM) - 12.5 PSI (0.86 Bar)
50 GPM (189.27 LPM) - 19.5 PSI (1.34 Bar)
60 GPM (227.12 LPM) - 29 PSI (2.0 Bar)
30 GPM (113.56 LPM) - NA
60 GPM (227.12 LPM) - 1 PSI (0.07 Bar)
100 GPM (378.54 LPM) - 3 PSI (0.21 Bar)
130 GPM(492.10 LM) - 5 PSI (0.34 Bar)
Measuring range is partly dependent on the selected type and size of connectors.
The flow meter is bidirectional for mounting purposes.
Electrical Data
801 Flow Meter
802 Flow Meter
Sensor
Open collector NPN
50% square wave
10-300 Hz in operating range
Open collector NPN
50% square wave
10-300 Hz in operating range
Calibration Number (Approximate)
TeeJet Controller - 82 pulses/liter
Mid-Tech Controller - 310 pulses/gallon
Raven Controller - 820 pulses/10 liter
Raven Controller - 3100 pulses/10 gallons
TeeJet Controller - 21 pulses/liter
Mid-Tech Controller - 79 pulses/gallon
Raven Controller - 210 pulses/10 liter
Raven Controller - 790 pulses/10 gallons
LED Indicators
Green-Power
Orange-Signal
Green-Power
Orange-Signal
Measuring Data
801 and 802 Flow Meters
Body & Insert
30% glass filled polypropylene
Shaft
410 hardened stainless steel
Turbine & Bearing Support
20% talc filled polypropylene
Bearing
Sapphire
Bearing Housing
303 stainless steel
Warranty
The warranty on this equipment may be affected for the following reasons:
•
Improper installation
•
Obvious abuse
•
Lack of, or improper maintenance
•
Employed in a manner inconsistent with its intended use
•
Used with chemicals that are incompatible with the materials which this product is made of
(See “Warranty and Limitations” statement in your controller manual for other limitations)
This flow meter is manufactured using some or all of the following materials:
•
303 Stainless Steel
•
410 Stainless Steel
•
Polypropylene
TeeJet Technologies does not recommend metering any product that reacts with these materials and damage resulting from the use of such products will not be
covered under the warranty. Please contact your chemical supplier to verify that the chemicals you are using are compatible.
If you have any questions about installation or use, refer to the installation section of your manual or call your TeeJet Technologies dealer.
