Quickstart Guide SP-Mount-1
Step 1
Mount part 1 to the desired surface.
Optimal height is between 10 and 20
feet. (Fig. 1)
Step 2
Mount the radar to part 3. Circular slots
can be used to change the roll of the
radar.
Step 3
Insert the stud on part 2 into the hole on
part 3 and attach the handle.
Step 4
Insert the stud on part 2 through the
hole in part 1 and attach the handle.
Angular adjustment
instructions on back
TIP
Once the handle is threaded, pull
outward and the handle will rotate freely.
With the handle pulled out, a flathead
screwdriver can be used to tighten, if
needed.
WARNING:
When connecting Ethernet to
radar, always use grounded
shielded CAT5 cable.
Fully Assembled
made from stainless steel and
rust resistant parts
Use these three
locations to mount
a C20, C40, CK2,
or CK10
Use these four
locations to mount a
C550, C950, A2000,
or C1500
Radar Roll Adjustment:
Step 5
Adjust to the desired angles and tighten
all positioning screws and handles. (
See
back side for details
)
Part1
Part2
Part3
Step 2
Step 3
Step 4
Fig. 1
Optimal
mounting
height
Common
mounting
height
Radar can be
mounted lower
than 6’ but range
performance is
decreased
Release Date: 05/23/2019
Rev.003
4 5/16 in x 4 ¼ in
