NAILER CONNECTION AND OPERATION
NOTE:
The information contained in this manual is designed to assist you in the safe
operation of the nailer. Some illustrations in this Manual may show details or attachments
that are different from those on your nailer.
Air Supply, Connections and Operating Pressure
Read section titled SAFETY. Make sure of the following before operation: Air Supply
Power Source (Compressor)
•
Use only clean, dry, regulated compressed air as a power source.
•
NEVER use oxygen or other bottled gases, as an explosion may occur.
•
Use suitable air compressors used to supply compressed air to this tool.
•
Moisture or oil in the air compressor may accelerate wear and corrosion in the
tools.
•
Drain daily.
Connections
1. Fittings
Install a female coupling to the hose. The female coupling will connect to the quick release
that fits the tool.
2. Filter-Regulator-Lubricator
•
NEVER connect the tool to pressure which potentially exceeds 120psi.
•
Filter-regulator-lubricator units supply an optimum condition for the tool and extend
the tool life. These units should always be used.
Filter
•
The filter removes moisture and dirt from compressed air.
•
Keep the filter clean by maintaining regularly.
•
Drain daily.
Regulator
•
The regulator controls the operating pressure for safe operation of the tool.
•
Inspect the regulator before operation to be sure it operates properly.
Summary of Contents for SFN19
Page 13: ...TOOL SCHEMATIC SFN19 ...
