Lucciola
Lucciola
6
FOCUS AND REGULATION
The luminaires should be placed at the minimum
distance from the object it is illuminating, as indicated
on the label.
Using the side handle
②
(for LUN 100, SUPERLUT,
SUPERLUT 100, LUBS 35) or the knob
⑥
(for LUT) it is
possible to loosen the projectors when they are locked
in a certain position and thus change their inclination.
In the same way, the projectors can be rotated with
respect to their vertical axis by rotating on their
hooking hinge.
CHANGING THE LAMP
Open the projectors by means of the knobs
④.
Using the appropriate terminals, tighten and take off
the lamp retaining ring
⑤
.
Extract carefully the lamp from its lodging paying
attention not to tear off the supply cables.
-
LUN 100
and
LUBS 35
: rotate the lamp
⑦
on
its holder
⑩
counter clockwise to remove it, and
clockwise to insert it;
-
SUPERLUT and SUPERLUT 100
: disconnect the two
female faston
⑫
from the male faston
⑪
of the
lamp
to be replaced and connect them to the new
lamp.
-
LUT
: loosen the socket lamp screws
⑨
and remove
the faston
⑧
; insert the faston on the new lamp
socket, tight the screws, verifying that the faston is
correctly inserted and tightened.
Place the new lamp in its loding and block with the
retaining ring
⑤
checking that it is duly inserted and
that it is blocking the lamp correctly. Screw again the
knobs
④.
Use only the lamps listed in the lampe table.
IMPORTANT NOTICE for LUBS 35
•
WARNING:
Start off of high voltage lamp: never
insert or remove the lamp when fixture is powered on.
•
WARNING:
Immediately switch off and replace the
lamp when the front safety glass breaks, even though
the lamp is still working.
•
On cold start, the lamp will take a few minutes to
attain full brighness.
•
Once switched off, wait approximately 5 minutes
before relamping.
•
Let the lamp cool down completely before opening
the projector.
•
This luminaire cannot be connected to a dimmer
CLEANING
For utmost projector performance, the reflectors must
be kept as clean as possible.
MAINTENANCE
The projectors must be serviced at least once a year to
check the integrity of their electrical and mechanical
parts. For this purpose, you should conctact only a
qualified dealer, to ensure proper service.
RECYCLING
The product must be recycled or disposed of,
according to Directive 2002/96/CE.
WARNING: For safety reasons always
disconnect the luminaires from the mains
before opening them to change the lamps
