Sportstar Outdoor Pioneer II, User Manual

Page: 18 / 55

Continue holding S4 until the watch displays the Current altitude. The word
CURRENT will be flashing.
Press S1 or S2 to select which parameter to set. Following is the sequence of setting
when you press S1:
Current Altitude
→
Local 1 Local 2 Local 3 Max Altitude Accumulated Altitude
Altitude Alarm
→
back to Current Altitude
The sequence will be in reverse if you press S2.
Press S3 to set the selected parameter. The digits will start to flash
Press S1/ S2 to change the value of the flashing digit
Press S3 to select another parameter to set.
Press S4 to exit setting mode. The watch will auto exit setting mode if there is no
button operation for 2-3 minutes.
The watch has 3 preset Altitude value Local 1, Local 2, and Local 3. Each can be set
by the user to his desired value which saved into the watch memory. The user can
select among the preset values (Local 1, 2, 3) to replace the current value. This done
by going to the preset value for example Local 1 and then press S4 to save the
selection. The next time you enter Alti setting mode the Current value will be replaced
by the value of Local 1.
Accumulated altitude and Max altitude cannot be set but will be reset to zero when
you press S3 and then S1 or S2.
The last field in the Alti setting mode is the Alti Alarm. To turn on the alarm press S3
and then press either S1 or S2. Press S3 again to set the altitude value at which the
alarm will sound. To increase the value press S1. To decrease the value press S2.
→ → → → →