17
Place the playground equipment on level ground and not less than
6ft (1.8m) from any structure or obstruction such as a fence, garage,
house, overhanging branches, laundry line, or electrical wires.
ASSEMBLY INSTRUCTIONS
Do not install the playground equipment over concrete, asphalt,
packed earth, or any other hard surface; a fall onto a hard surface
can result in serious injury or death to the equipment user.
Adequate overhead clearance is essential.
A minimum clearance from
ground level shall be recommended. Provide clearance for wires, tree
limbs, and other possible hazards.
Use the equipment in a well-lit area. Artificial illumination may be required
for shady
areas.
Secure the equipment against unauthorized and unsupervised use.
The owner and supervisors of the trampoline are responsible to make all
users aware of practices
specified in the use instructions.
For ease of installation, do not over-tighten the nuts and bolts when
you are first putting the equipment together. This will allow room
for adjustments during installation.
TIGHTENING NUTS & BOLTS
Once you have finished assembling each component of the play set,
make sure to go back over each step and properly tighten all nuts,
bolts and plastic caps. Check the entire unit to ensure all parts are
properly assembled before allowing children to use the playground
equipment.
Summary of Contents for MSC-3878
