801-312-H See Saw 6 Seat
Page
3
Rev. 09/10/2010
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
www.sportsplayinc.com
GENERAL INSTRUCTIONS:
Car tires (not furnished) or some other shock-absorbing material should be
embedded in the ground beneath the seats to minimize the risk of injury due
to abrupt contact with the ground. Also, lengths of standard 2 x 4’s can be
easily positioned between the pipe rails to prevent children from putting
their feet between the rails.
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged or broken parts. Tighten and/or
replace immediately.
SPECIFIC ASSEMBLY AND INSTALLATION:
NOTE:
All button head nuts are placed on the pipe side of the spots where
attached and the lock washers are placed on the Bolts. DO NOT tighten
nuts more than hand-tight until entire assembly is completed.
STEP #1: Assemble frame by first attaching one leg to 8’ long top rail using
elbow. Tighten with set screws. Slide fulcrum over top rail to elbow by
leg, then sleeve so holds fulcrum in place. Tighten sleeve with set
screw to bottom of top rail. Attach middle leg to center fitting and
slide over top rail. Position so middle leg will be 3’7” from first leg.
Tighten to top rail. Then slide another fulcrum onto the top rail down
to the center fitting, followed by another sleeve. Tighten sleeve to
bottom of top rail so holds fulcrum against center fitting. Finally
slide last sleeve, then fulcrum onto top rail, position last leg into
elbow and onto top rail. Slide last fulcrum and sleeve back up against
elbow and secure with set screws. DO NOT attach see saws at this time.
STEP #2: Using assembled frame as your template, mark and dig footing holes.
STEP #3: Prop in holes, leaving 15-18” distance from resilient surface to top of
frame, plumb, level and pour concrete. Allow at least 48 hours for
concrete to harden.
STEP #4: After concrete has hardened, attach the rest of the equipment. Use the
5/16” x 2 1/4” button head bolts, lock washers and button head nuts to
attach the long pipe supports to the fulcrums. Use the 5/16” x 3” button
head bolts, lock washers and button head nuts to attach the seat and
handle to the pipe supports. Use Threadlocker on all button head
fasteners. Drive pipe plugs into the open ends of the pipe supports.
STEP #5: Attach Warning Label and Manufacturer’s Identification Label to a clean
surface. The labels should be attached in a location where they are
clearly visible and legible and away from normal hand and foot placement
areas. The labels must be replaced if they become illegible, destroyed
or are missing. Contact your SportsPlay distributor for replacement
labels.
