801-178 20’ SINGLE ENTRY BIKE RACK (Perm)
Page
2
Rev 03/19/03
SPORTSPLAY EQUIPMENT, INC. © 1991 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
GENERAL ASSEMBLY INSTRUCTIONS:
Check all the parts and hardware with the packing list too be sure
you have received everything needed to assemble this product.
CONTACT YOUR LOCAL DISTRIBUTOR OR SPORTSPLAY EQUIPMENT WITH
NOTIFICATION OF ANY MISSING OR DAMAGED PARTS. Contact must be made
within ten days of receipt of your order.
Only hand tighten nuts & bolts on initial assembly. Final
tightening should be done EVENLY after final assembly when unit has
been plumbed & leveled.
After assembly is complete, ANY ENDS OF BOLTS PROTRUDING BEYOND
NUTS SHOULD BE CUT OFF AND/OR PEENED OVER TO REMOVED ANY SHARP
PROJECTIONS. Go over entire unit to file smooth any sharp edges or
projections that may have been caused by rough handling in shipping
or installation.
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged or broken parts. Tighten
and/or replace immediately.
SPECIFIC ASSEMBLY INSTRUCTIONS:
Step #1
Assemble bike rack as per drawing on page 1. Start by
attaching #803-268 Spacer Bar to one end support and
the center support.
Step #2
Attach ladder to end supports using T-Clamps. The top
of the center support slides over the top rail of the
ladder. The bottom of the center support is attached
with a T-clamp.
Step #3
Attach other end of bike rack following same procedure.
Step #4
Drive in pipe plugs on all open pipe ends.
Step #5
Attach Anchor Bolts to end supports and place Bike Rack
in position over footing holes.
Step #6
Pour concrete. Wait 48 hours before using equipment.
T-Clamp Detail:
