551-110 Baseball Backstop
Page
2
Rev 05/22/08
GENERAL ASSEMBLY INSTRUCTIONS:
1. Check each piece carefully and remove any sharp projections that may
have been caused by shipping.
2. DO NOT Tighten nuts more than hand tight until entire assembly is
completed.
3. All Threaded ends of bolts protruding beyond nuts should be cut off and
peened over to remove any sharp edge.
SPECIFIC ASSEMBLY INSTRUCTIONS:
1. Layout and dig holes
2. Assemble backstop on ground with bottom of upright posts at front edge
of holes. Tighten all bolts securely.
3. Raise and lower assembly into holes.
4. Plumb and Level backstop.
5. Pour footings. Approximate concrete required – 4.7 cubic feet.
MAINTENANCE INSTRUCTIONS:
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
Check periodically for loose bolts, broken parts and replace immediately.
