302-141 Rabbit Hutch (Portable)
Page
3
of 3
Rev
02/20/2020
GENERAL ASSEMBLY INSTRUCTIONS:
Check all parts and hardware with the packing list to insure you have received everything needed to
assemble this product. Contact your SportsPlay distributor with notification of any missing or
damaged parts. Contact MUST be made within ten days of receipt of your order.
Check MONTHLY for loose bolts, damaged or broken parts. Tighten and/or replace immediately. On
swings and any equipment that uses S-Hooks and/or Swing Hangers check the bearing surfaces for
wear. Replace any parts that show a reduction of 25% from the original size.
ASSEMBLY AND INSTALLATION:
NOTE:
All threaded ends of bolts protruding beyond nuts must be cut off and/or peened to
eliminate sharp edges. No more than two threads should extend beyond face of nut.
All washers “T” nuts, and other fastener hardware used on round pipe or tubing must
be hammered down to conform to the curved underlying surface to eliminate catch
points. DO NOT tighten nuts more than hand-tight until entire assembly is
completed.
STEP #1:
Place Ring Ladder onto ground with ring that has four (4) holes in it facing
upwards.
STEP #2:
Invert the shell, turning it upside Down, placing it on top of the 2 Ring ladder.
STEP #3:
Attach the 2 Ring ladder to the shell using hardware specified in Page 1 sketch.
STEP #4:
Install black plastic caps over open end of legs.
STEP #5:
Attach shell legs to shell.
STEP #6:
Check and tighten all bolts and nuts.
STEP #7:
Turn completed assembly right side up.
STEP #8:
Attach warning label and Manufacturer’s Identification label to a clean surface.
The labels should be attached in a location where they are clearly visible and
legible and away from normal hand and foot placement areas. The labels must be
replaced if they become illegible, destroyed or removed. Contact your SportsPlay
distributor for replacements.