SportsArt Fitness G572U, Owner'S Manual

Page: 58 / 68

55
9. MAINTENANCE
MAINTENANCE Messages
This product can show the following messages.
Three flashing lines indicate that the unit is entering power saving mode. This mode
shuts off workout feedback information. It is activated 50 seconds after no one
presses keys or moves pedals.
NOT GRID
This message indicates that the unit has entered the “not grid” mode, in which a
large resistor supplies resistance, usually due to inverter malfunction. This mode is
activated by flipping a switch on the boost converter box. In this mode, power is not
sent to the inverter. The alternator in the product supplies a maximum of 100 watts of
resistance. If the large resistor gets too hot, resistance output is limited to 50 watts.
When the operating temperature cools, resistance will again increase to 100 watts.
ERR1
This message indicates that the inverter is overloaded. It can appear once every 30
seconds after a workout has begun. At this time, the fitness product can operate
normally except for the resistance function. There will be no resistance. To remedy
the situation, turn off unit power. Then turn on unit power to recover normal
operation. Inspect the accuracy of the setting for the number of units in the pod.
Refer to instructions for setting the number of fitness products per pod.
ERR2
This message indicates that the large resistor is too hot. It only appears when the
resistor is too hot. At this time, the product will not be operational.
ERR4
The large resistor is not operating. At this time, the product will not be operational.
---