31
STEP 6
Align the Walk Belt
*Make adjustments as needed, but avoid turning rear roller screws more
than one quarter rotation at a time.
*See next page for the illustration provides an overview of this step.
(a) First, make sure the treadmill is on a leveled surface and the incline is at
0%.
(b) Start the speed at a lower rate of 3kph/2.5mph to check if the walk belt is
aligned. Adjust the rear roller screw in area A if necessary to make sure
the walk belt fall in the middle of 2 green labels in the front of the deck.
(The distance between deck and rear roller on both sides of walk belt is
tolerable.)
(c) Adjust the speed higher to 15kph/10mph or above to ensure the belt is
aligned.
(d) Let the treadmill run for 2 minutes or more to see if the walk belt moved. If
so, repeat the procedure (b). (Adjust the rear roller screw slowly to avoid
the walk belt touches the treadmill to cause the damage.)
(e) Let the treadmill rotate backward for 2 minutes to see if the walk belt
touched the landing strips. If so, repeat the procedure (b) to ensure the
walk belt does not touch the landing strips.
(f) Adjust the speed higher to 3.5kph/3mph to ensure the walk belt is aligned.
If the walk belt does not fall in the middle of 2 green labels, loosen the
screws in area B. Press the left guide wheel if the walk belt moved to the
left side or press the right guide wheel if the walk belt moved to the right
side.
(g) Rear guide wheel adjustment instruction
1. Loosen the screws in area B and insert M5 wrench into the hole of
screws in area C to press D shaft down to move the walk belt. Avoid
moving the walk belt more than half misalignment .
2. Secure screws in area B against D shaft to secure it in this position.
3. Let the treadmill run for 2 minutes and let the treadmill rotate forward
and then repeat the procedures (c) (d) to ensure the walk belt is
aligned. Repeat the procedures (c) through (g) two or three times to
ensure the walk belt fall in the middle of 2 green labels.
(Note: While the treadmill rotating backward, adjust the side there is
misalignment only.)
