8
8. TROUBLE SHOOTING
Low Battery Indicator
7. PROGRAMMING ADDITIONAL FINGERPRINTS (CONTINUED)
Press the reset button and follow
Section 4 instructions again, for
each fingerprint zone you would
like to program.
If you experience any problems
reading your fingerprint, including
inconsistent readings, note the
area of your fingerprint that
doesn’t work properly, and
specifically re-program that area.
This scanner will hold up to 100
different fingerprints.
In the event that you run into issues with programming and accessing your
vault, please read through this section for answers to your questions.
BEEP
BEEP
BEEP
HOLD FOR BEEP
LIFT FINGER
2 BEEPS + 2 GREEN FLASHES = SUCCESS!
If you notice your indicator ring is not
remaining on for a few seconds upon entering,
replace batteries immediately to avoid being
locked out of your vault.
Placing a portion of a fingerprint on the scanner that
has not been programmed can result in an error. We
recommend programming multiple areas of each
fingerprint.
Make sure batteries are fresh. We suggest high grade
alkaline. Do not mix old and new batteries. No not use
rechargeable batteries.
Make sure you are placing the same part of your finger
print on the scanner that was used for programming. If
not, make note of the area that is not scanning and
program that area specifically.
SOLUTION
PROBLEM
YOUR PROGRAMMED
FINGERPRINT IS NOT
READING AT ALL TIMES
