6
1-866-748-6748
www.sitmeanssit.com 7
Prepare the Collar Receiver
Charge the Collar Receiver
1. Lift the rubber cover protecting
the Charging Jack.
2. Connect the charger connector to
the Charging Jack.
3. Plug the charger into a standard
120-volt AC wall outlet.
4. Charge the Collar Receiver for
24 hours for the first charge.
Recharges take only 6 hours.
Note: The Receiver Indicator Light
will flash after 6 hours of charging.
For the first charge, continue to charge
the Collar Receiver for an additional
18 hours.
5. When charging is completed,
replace the rubber cover.
Charger connector
placed in Collar Receiver
Charging Jack
If the Collar Receiver is used in or around salt water, the Collar Receiver should be
rinsed with fresh water following each use. Prior to rinsing, the rubber charging jack
cover should be removed from the power plug socket and left out until the Collar
Receiver has air dried.
To Turn the Collar Receiver On:
1. Press and hold the On/Off Button until
the Receiver Indicator Light comes on
and the Collar Receiver beeps 5 times.
2. Release the On/Off Button.
The Receiver Indicator Light will flash
until the Collar Receiver is turned off. The
flashing light indicates the Collar Receiver
is ready to receive a radio signal from the
Remote Transmitter.
On/Off Button
To Turn the Collar Receiver Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Collar Receiver beeps 2 times.
2. Release the On/Off Button.
To extend the life between charging cycles, turn the Collar Receiver off when it is not in use.
Note: Approximate battery life between charges is 40 hours, depending on frequency of use.
Receiver Indicator Light
Operational Mode LED
Color
LED Function
Battery
Status
Speaker
Function
Unit is turned on
via On/Off Button
Green LED is solid in color during
beep sequence
Good or
Low
Beeps 5 times
Unit is turned off
via On/Off Button
Green LED is solid in color during
beep sequence
Good
Beeps 2 times
Unit is turned off
via On/Off Button
Green LED is solid in color during
beep sequence
Low
Beeps 2 times
Unit is on
Green LED flashes once per second
Good
N/A
Unit is on
Green LED flashes once per second
Low
N/A
Unit is delivering
continuous
stimulation
Green
LED is solid in color for as
long as button is pressed
Good or
Low
N/A
Unit is delivering
momentary
stimulation
Green LED will quickly flash once
no matter how long button
is pressed
Good or
Low
N/A
Unit is delivering
tone
N/A
N/A
Good or
Low
Unit will beep
for as long as
button is pressed
Unit is charging
< 6 hours
Green
LED is solid
Unit is charging
> 6 hours
Green
LED is flashing once per
second
Rechargeable
Batteries
• The rechargeable Nickel Metal Hydride (NiMH) batteries are not memory sensitive and do not
require depletion before charging.
• The batteries come partially charged from the factory, but will require a full charge before the
first use (24 hours).
• Remember - Always keep batteries away from flame.
• When storing the unit for long periods, remember to regularly give batteries a full
charge (24 hours). This should be done once every 4 to 6 weeks.
• Excessive overcharging can shorten battery life. After initial charge, it is not recommended to
leave the battery plugged in for more than 12 hours.
• If your equipment has not been charged for an extended period, you may experience a decrease
in battery life the first few uses. Afterwards, the battery life will return to previous capacity levels.
• You should expect hundreds of recharge cycles from your batteries. However, all rechargeable
batteries lose capacity over time relative to the number of recharge cycles they experience. This is
normal. If your operating time drops to half of the original life, contact Sit Means Sit to purchase
a new battery.
• The batteries should last for a period of 3-5 years. When a battery needs replacement, you can
order a new pack by calling Sit Means Sit at 1-866-748-6748. Please do not open the Collar
Receiver or Remote Transmitter until you have received the replacement.
Step
2
400-931-1.indd 6-7
1/3/12 1:49 PM
