www.sportdog.com/international
11
Mode
UPPER BUTTON
FUNCTION
LOWER BUTTON
FUNCTION
SIDE BUTTON
FUNCTION
7
Dog 1
Continuous Correction with
no tone
- correction level set by knob
Dog 2
Continuous Correction with
no tone
- correction level set by knob
Dog 3
Continuous Correction
with no tone
- correction level set by
knob
8
Dog 1
- Continuous Stimulation
with no tone - correction level
set by knob - when button
is released there is
1
/
2
second
delay followed by tone, which
lasts for 1 second (if button
is pressed again before
1
/
2
second delay, then tone is not
delivered).
Dog 2
- Continuous Stimulation
with no tone - correction level
set by knob - when button
is released there is
1
/
2
second
delay followed by tone, which
lasts for 1 second (if button
is pressed again before
1
/
2
second delay, then tone is not
delivered).
Dog 3
- Continuous Stimulation
with no tone - correction
level set by knob - when
button is released there is
1
/
2
second delay followed
by tone, which lasts for
1 second (if button is
pressed again before
1
/
2
second delay, then tone is
not delivered).
Note: In Mode 4, 6, 7 or 8, the “high” and “low” ends of reading on Intensity Dial are within the
level set by the Intensity Dial. For example, if the Intensity Dial is set to 4, the Upper Button will
deliver Stimulation lower than level 5, and the Lower Button will deliver Stimulation higher than
level 3, but the Upper Button will deliver stronger Stimulation than the Lower Button.
_____________________________________________________________
Reset the Collar Receiver
To reset the Collar Receiver to work with a new Remote Transmitter or to reprogram a
new Collar Receiver to work with your existing Remote Transmitter:
1. Turn the Collar Receiver off.
2. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then
turn off after 4-5 seconds. If the On/Off Button is released too early, the Receiver
Indicator Light will begin fl ashing as normal. If this occurs, start over and repeat the
process.
3. After the Receiver Indicator Light has turned off, release the On/Off Button.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 0.5-1m from each
other before this occurs. Once the Receiver Indicator Light has fl ashed 5 times, the
Collar Receiver has been reset and will begin fl ashing as normal. If the Receiver
Indicator Light does not fl ash 5 times, start over and repeat the process.
_____________________________________________________________
Program the Collar Receiver for Two or
Three-Dog Operation
With the Transmitter set to Mode 5, 6, 7 or 8, SportDOG
™
Collar Receivers can be
set to respond to the upper, lower, or side Remote Transmitter buttons. SportDOG
Add-A-Dog
®
receiver(s) must be purchased to train additional dogs.
1. Program the Remote Transmitter to Mode 5, 6, 7 or 8.
2. Program the fi rst Collar Receiver.
Step
6
Step
7
Summary of Contents for SportHunter 800
Page 149: ...www sportdog com international 149...
Page 150: ...150 www sportdog com international...
Page 151: ...www sportdog com international 151...
