Step II — Activate the Receiver Collar
• To activate the receiver collar, press and release the receiver’s on/off button.
• When the button is pressed, the LED will immediately come on and then flash twice
after the button is released, indicating that the receiver is ready to receive signals.
• To turn off the receiver collar, press and release the on/off button. The LED light will
come on when the button is pressed and will flash three times after the button is
released, indicating that the unit has been turned off.
TESTING YOUR UNIT BEFORE USING
Note: An alternative way for quickly checking whether or not the receiver is on is to press the
top
button on the transmitter. Pressing this button will result in the receiver to beep only.
• Turn off the receiver by pressing the on/off button.
The receiver LED will flash three times.
• Loosen the two contact points on the collar until
the threading is exposed.
• Bend the wire ends of the test light and twist them
around the exposed threading.
• Securely hand-tighten the contact points over the
test wires.
• Activate the receiver by pressing the on/off button.
The LED will blink once.
• Turn the adjustment knob on the transmitter to level 5.
• Press the Stimulation button.
• The test light will illuminate, indicating that the unit is operational.
• The higher the intensity level that is set on the transmitter, the brighter the light
will shine.
• Loosen the contact points, remove the test wires, and securely tighten the contact
points. Do not over tighten.
4
Push button
(on/off) switch
Test Light on Receiver Probes
