www.sportdogbrand.com 11
Reset the Collar Receiver
To reset the Collar Receiver to work with a new Remote Transmitter or to reprogram a
new Collar Receiver to work with your existing Remote Transmitter:
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then
turn off after 4-5 seconds. If the On/Off Button is released too early, the Receiver
Indicator Light will begin fl ashing as normal. If this occurs, start over from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 2-3 feet from each
other before this occurs. Once the Receiver Indicator Light has fl ashed 5 times, the
Collar Receiver has been reset and will begin fl ashing as normal. If the Receiver
Indicator Light does not fl ash 5 times, start over and repeat the process.
_____________________________________________________________
Program the Collar Receiver for
Two-Dog Operation (Mode 2)
SportDOG Collar Receivers can be set to respond to either the left or right toggle switch
position. A SportDOG Add-A-Dog™ receiver must be purchased to train a second dog
in two-dog mode.
1. Program the Remote Transmitter to mode 2
(see page 10).
2. Flip the toggle switch to the left position to
program the fi rst Collar Receiver.
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver
Indicator Light will come on, then turn off in 4-5
seconds. If the On/Off Button is released too early,
the Receiver Indicator Light will begin its normal
fl ashing. If this occurs, start over and repeat from A.
C. After the Receiver Indicator Light has turned
off, release the On/Off Button.
D. Press and hold the Upper Button on the
Remote Transmitter until the Receiver Indicator
Light fl ashes 5 times. You may need to hold both
units 2-3 feet from each other. If the Receiver
Indicator Light does not fl ash 5 times, start over
and repeat from A.
Set toggle left for Dog 1
and right for Dog 2
3. Program the second Collar Receiver the same way using A. through D. above, but
with the toggle switch set to the right position.
Step
6
Step
7
