10 1-800-732-0144
WWW.SPORTDOG.COM 11
TO SWITCH BETWEEN NORMAL AND EXPANDED MODE
1. Press and hold the Change Tone/Mode Selection Button on the Transmitter for 5 seconds. When a “P”
appears, release the button.
2. Use the Launcher Selection Up/Down Buttons to scroll through and select “E” for Expanded Mode or “—“ for
Normal Mode. “U” is for User ID, see below.
3. Press the Change Tone/Mode Selection Button again and your selection will flash rapidly, indicating that the
mode has been selected.
NOTE: It is necessary to rematch Receivers each time you switch between Expanded Mode and Normal Mode
(see Step 6).
TO SET USER ID
The User ID can be set so more than one Transmitter can control the same Receiver. An unlimited number of
people may share a unique User ID. All Transmitters would need to be programmed to either Normal Mode or
Expanded Mode.
1. Press and hold the Change Tone/Mode Selection Button on the Transmitter for 5 seconds. When a “P”
appears, release the button.
2. “E” or “—“ will appear, depending on what mode is set.
3. Use the Launcher Selection Up/Down Buttons to select “U” to set the User ID.
4. Press the Change Tone/Mode Selection Button. A “—“ or number 0-9 will appear.
5. Use the Launcher Selection Up/Down Buttons to select a number 0-9. This is your User ID.
6. Press the Change Tone/Mode Selection Button again and your number selection will flash rapidly, indicating
that the User ID has been set.
7. To confirm your selection, follow steps 1-4. The number that appears is your User ID.
NOTE: It is necessary to rematch Receivers each time you change the User ID (see Step 6). To return unit to the
factory ID, simply select “—“ in step 5 above.
PREPARING THE TRANSMITTER
TO CHARGE THE TRANSMITTER
1. Lift the rubber cover protecting the Transmitter Charging Port.
2. Connect the appropriate charger connector to the Transmitter.
3. Plug the charger into a standard 120/240-volt AC wall outlet.
4. The Transmitter will be fully charged after 2 hours.
5. Battery charge is indicated by a battery icon on the Transmitter’s LCD screen.
A full battery indicates charging is complete.
6. When charging is complete, unplug the charger and replace the rubber cover.
Using Lithium-Ion technology, the Transmitter only requires a 2 hour charge. It
is not harmful to let the unit charge more than 2 hours.
TO TURN THE TRANSMITTER ON/OFF
There is no on/off button on the Transmitter. When charged, the LCD screen will turn on when a button is pressed,
stay on for a few minutes, and then time out automatically if no other action is taken.
NOTE: Approximate battery life between charges is 80 hours, depending on frequency of use.
PREPARING THE RECEIVER
TO CHARGE THE RECEIVER
1. Pull down the mud plug cover to expose the
Receiver Charging Port.
2. Connect the appropriate charger connector to the
Receiver Charging Port.
3. Plug the charger into a standard 120/240-volt AC
wall outlet.
4. The Receiver will be fully charged after 2 hours.
5. Battery charge is indicated by a battery icon on
the Receiver’s LCD screen. A full battery indicates
charge is complete.
6. When charging is complete, unplug the charger and close the mud plug cover.
STE
P
:: 0
4
STE
P
:: 0
5
P D S
1 2 3 4
P D S
1 2 3 4
