www.sportdogbrand.com
7
Reset the Add-A-Beeper
™
To reset the Add-A-Beeper to work with a new Remote Transmitter or to
reprogram a new Add-A-Beeper to work with your existing Remote Transmitter:
A.
Turn the Add-A-Beeper off.
B.
Press and hold the On/Off Button. The Add-A-Beeper’s Indicator Light will come
on, then turn off after 4-5 seconds. If the On/Off Button is released too early, the
Add-A-Beeper’s Indicator Light will begin fl ashing as normal. If this occurs, start
over and repeat from
A.
C.
After the Add-A-Beeper’s Indicator Light has turned off, release the On/Off Button.
D.
Press and hold the Locate Button for the UplandHunter
™
Transmitter or the Tone Only
Button on all other Remote Transmitters (except SD-3200) until the
Add-A-Beeper’s Indicator Light fl ashes 5 times. You may need to hold both units 2-3 feet
from each other before this occurs. Once the Add-A-Beeper’s Indicator Light has fl ashed
5 times, the Add-A-Beeper has been reset and will begin fl ashing as normal. If the Add-
A-Beeper’s Indicator Light does not fl ash 5 times, start over and repeat from
A.
