IP Video HD Intercom Terminal User Manual
Alarm parameters
Parameters specification as following:
Emergency
alarming
Alarm source is “emergency alarm” port of external alarm control module, alarm
trigger modes are following three kinds.
Open circuit alarm: when the port is off to trigger alarm:
Close circuit alarm: closed port to trigger alarm;
Status alarm: closed port to trigger alarm, when the port is off to remove alarm.
Priority level: task priority level, the smaller the priority number, the higher the level. If
two alarm (or task) are triggered at the same time, terminal response the higher
priority level alarm and also lighten the three color door light.
After the emergency alarm port is triggered, the three color door light is flashing.
When the alarm is disabled, the three color door light will be off.
Click terminal “alarming button” also will lighten the three color door light (flashing in
red), when alarm is disabled, the light is off.
Motion detection
alarm
Alarm source is “motion video detection” port of external alarm control module, alarm
trigger mode is the same with emergency alarm.
Enabled, when terminal receive the motion detection alarm signal of the external
camera to lighten the three color door light(flashing in yellow).When alarm is
disabled, the light is off
Priority level is the same with emergency alarm.
Door magnetic
state
Enabled, when the terminal detect the door magnetic is opened, lighten the three
color door light, when door magnetic 1 is opened, three color door light is green on,
when door magnetic 2 is opened, three color light is blue on. After the door magnetic
is closed, light is off.
11
Summary of Contents for NAS-8523CV
Page 1: ......
