| 9
EN | instructioni
4. CONSOLE INSTRUCTION
KEY FUNCTIONS:
•
MODE:
This key lets you to select and lock on
to a particular function you want.
•
SET:
Can to proceed the data establish for
“TIME” “DISTANCE” “CALORIES”“PULSE”.
•
CLEAR(RESET):
The key to reset the value to
zero by pressing the key.
•
ON/OFF(START/STOP):
The key to pause the signal input by pressing
the key.
STEP 3 (see fig D):
• Put the front post (7) into the front post deco-
rative cover (28) first.
• Connect the console wire(14) and spead
senor wire(16) together. At the same time,
connect the resistance adjusting wire(17&18)
together, too. Please ensure that all the pins
are straight when connecting 14&16 and
17&18. Failure to do so will result in console
malfunction.
• Attach the front post(7) to the main frame (1)
with Screw(63), flat washer(55) and curved
washer(66).
STEP 4 (see fig E):
• Install the console(9) on the front post(7)
with the screws(68).
• Take out the protective plug(67), put the pul-
se sensor wires(19) on the handle bar(8) into
the hole that on the front post (7) and pull it
out. After that, put the protective plug(67)
back into the hole .Fix the handle bar(8) on
the handle bar fixing socket with the T-Shape
knob (51) and decorative part (52) properly.
Be careful not to snag the pulse sensor wire
connected to the handle bar as it will affect
the heart rate measurement.
• Connect hand pulse sensor wires(19) and
main console wires(14) firmly, ensuring a
good connection. Push all excess wires back
frame(1) with the saddle post decorative co-
ver(6) and line up the holes. Secure the saddle
in position with the adjusting knob (10). The
correct height for the saddle can be adjusted
after the bike is fully assembled.
Note:
Do not exceed the mark”stop”.
down the stem until the console sits on the
bracket.
• When connecting the console to the bracket,
please note that all the fixings are already
preassembled to the back of the console.
Caution:
Now the equipment is completed assembled,
if you find it not leveled on the floor, you can
adjust it by the adjusting rear stabilizer tube
plug(13). Make sure you have tightened all
the screws and nuts well before beginning
your workout.
