Data di emissione:
Maggio, 2016
Revisione:
6
Pag. :
49/64
Defrost temperature setting (only for SP2
and SP3 electronic version)
In the SP2 and SP3 electronic version it is
possible to set the refrigerating system cut in
and cut out temperatures during the defrost
mode.
During this defrost phase,
the cut in
temperature
is the maximum temperature over
which the refrigerating system is switched on
while
the cut out temperature
is the minimum
temperature under which the refrigerating
system is switched off.
In this way the defrost temperature will be
maintained between these two values.
!ATTENTION!
The software will automatically prevent to set
the cut in temperature lower than the cut out
one and vice versa.
In order to set these two temperature is
necessary to operate as described below:
-
Press the SET button.
-
The up arrow on the temperature value
right side indicates that we entered
inside the cut in temperature setting
menu; with the two arrows it is possible
to switch on the cut off temperature
menu as indicated by the down arrow on
the temperature value right side.
-
Once selected the temperature that is
necessary to modify, after pressing the
SET button the value will start blinking to
indicate that is now possible to modify it
by using the arrows.
-
Pushing again the SET button the °C or
the °F will start blinking to indicate that
is possible to switch from one to the
other.
-
Pushing for the last time the SET button
the set parameters will be memorized
and the temperature on the display will
stop blinking.
Fig. 9bis
