Date of issue: January 2018
Revision 1 Page 39/48
- Once assembled, insert the beater carefully
into the cylinder making sure that the rear
shank fits perfectly in its seat within the cylinder
(fig. 32).
!ATTENTION!
During the insertion of the beater inside the
cylinder grasp both the scrapers as shown in fig.
32 in order to keep them in position during the
insertion.
- After installing the piston seals and lubricating
them as necessary (fig. 33), insert the piston
into its housing in the flange, mount the
dispensing lever with its spring and connect
them with the fixing pin (fig. 33).
!ATTENTION!
An imperfectly fitted tap will compromise its
seal.
- Carefully lubricate the sealing gasket of the
front flange (fig. 34).
- Refit the flange so that the locating pin mates
with its seat (fig. 35).
Fig. 32
Fig. 33
Fig. 34
Fig. 35
