8
General Maintenance
Warning:
always disconnect the plug from the power supply before any maintenance is
started.
1.
Water Filter: Check the water filter on the motor base before attaching the water
tank. Clean the filter when necessary.
2.
Nozzle Clogged: A clogged nozzle will cause the operating pressure to be too high
causing the Splosh #2 to surge. If this happens turn the unit off and unplug pressure
washer:
•
Unplug power supply, pull trigger on spray nozzle handle to relieve
pressure, remove nozzle from hose.
•
Clean the spray nozzle with a pin. (See Diagrams 1&2 below).
•
Flush wand assembly backwards with water or compressed air.
•
If pressure is still too high, repeat steps 1-2.
3.
Lubrication: No lubrication is required for this pump. Silicone grease may be added
to hose connector O-rings if connecting becomes difficult.
4.
Add some silicone grease to the metal part of the spray nozzle if it has not been
used for a long time.
For battery:
1.
Do not store the unit in elevated temperatures for an extended period of time.
2.
Store the unit in a dry, cool and well-ventilated place, protect from direct exposure to
sunlight.
3.
The unit must be stored in a partial state-of-charge, ideally 50% (charge the battery for
about 2 hours), recommended temperature 0°C ~20°C, if it is not in regular use, charge
the battery to approx. 50% instead of fully charging every 3 months.
Summary of Contents for Splosh 2
Page 6: ...4 How to Assemble ...