7
6.
If Footblocks (H) have been purchased separately for your Titan3, distribute a FootBlock around
your pool at each leg. Attach a FootBlock to the base of each leg using the provided attachment
fittings. Then, during the course of filling the pool with water, make certain that the top of the
pool legs are still inserted into the top rail (or damage could occur to the white top rail
membrane), and that the foot straps are fully extended all around the pool.
Filling your
TitanPool3
1.
Your Titan3 will not stand up completely by itself at this point. However the walls will stand up
enough to allow for the longer wall top rail to fit inside of the shorter end walls. There must be a
solid support under each leg because, when the pool is filled, the weight on each leg will be
approximately 2000 lbs, and the leg will sink into soft ground. Either the Splash Footblock
should be used, or pressure treated two (2) 2” X 10”s cut approximately18” long should be
inserted under each leg and set into the ground.
2.
When the pool water depth has reached about 1”, stop filling. Pull all foot straps to assure they
are tight and that the foot is centered on the support base or FootBlock. Also check all legs to
assure they are fully inserted into the Wall Top Rail metal pipe. Continue filling with water.
3.
The Pool is full when the water level reaches a level about 3-4” from the Top Rail. You can use
the Warning Labels inside the pool as a gauge of the water level.
4.
IF THE FLOATING WEIR AND THE INTERNAL BASKET OF THE SKIMMER ARE REMOVED, THE
RESULTING STRONG SUCTION CAN TRAP HAIR OR OTHER BODY PARTS IF THEY ARE
INSERTED INTO THE SKIMMER.
NEVER WORK ON THE PUMP, FILTER, OR SKIMMER WHILE THE PUMP IS OPERATING,
OR SERIOUS INJURY COULD OCCUR DUE TO STRONG SUCTION!!
Summary of Contents for TitanPool3
Page 1: ...By Owner s Guide...
