Round
Ladder Instructions
If you have purchased a round pool, these instructions replace steps(7) and (9) in your SplashLadder Instruction
Manual.
Attaching the
round l
adder Berth Pipe to the Buttress Leg
Please note: The front holes (the ones closest to the pointed ends) in the
round l
adder Berth Pipe are for
round p
ool
sizes 12’ x 4’ and 16’ x 4. The rear holes are for
round p
ool sizes 20’ x 4’ and 24’ x 4’.
Parts Needed:
I.
Round l
adder “Horseshoe” Berth Pipe
P.
Round l
adder Mounting Brackets
O.
(4) Long Metal Screws w/Nuts and Washers
1. Select the desired
p
ool Buttress Leg for your
Splash
Ladder and place the “Horseshoe” Berth Pipe on top
of a
Buttress Leg. (The pointed end should face away from the pool.) 2. Take the two Long Metal Screws
and place them
vertically through the
Splash
Ladder “Horseshoe” Berth Pipe and the
l
adder Mounting Brackets
on the Buttress Leg.
Tighten with the corresponding Nuts and Washers. 3. Take the two remaining Long Metal
Screws and place
them horozontally underneath the Mounting Brackets and tighten with the corresponding Nuts
and Washers. 4.
The
Splash
Ladder “Horseshoe” Berth Pipe is now secure. 5. Slide the
Splash
Ladder Vertical
Supports into the
Splash
Ladder “Horseshoe” Berth Pipe until the snap couple system is in place. The
Splash
Ladder
assembly is now
complete.
1
2
3
4
5
8
Letter (I) is now the OmegaLadder
“Horseshoe” Berth Pipe
Letter (P) is now the OmegaLadder
Mounting Brackets
Letter (O) is now (4)Long Metal
Screws w/Nuts and Washers
I
P
O
O
O
O
P
Rear Hole
Front Hole
Rear Hole
Front Hole
©
2003-Splash Superpools Ltd.
Please replace the following letters with the corresponding diagram parts list on
page 1 of your SplashLadder Instruction Manual:
I
P
O
Summary of Contents for TitanPool3
Page 1: ...By Owner s Guide...
