7
14.Auto power off:
off/1 min/3 mins/5 mins
If there are no button actions when the camera is on standby, the camera
will auto power off to save power (unless the camera is on Motion
Detection mode). Here you can define the delay time.
15.Power off screen:
off/1 min/3 mins/5 mins
16.Stamp:
date and time/driver number stamp/off
After opening this function, relevant information will be shown in the
screen when a video is replayed on the computer. There are options to
show the date and time, driver serial number or off. Not all the information
will fit onto the video stamp do the decision needs to be made as to which
information is deemed most relevant.
17.Driver number:
Here you can define the driver number or your customized information
with 9 characters or numbers to help identify the recording.
18.GPS stamp:
on/off
19.Velocity stamp:
on/off
20.G-sensor sensitive:
2G/2.5G/3G/3.5G/4G/4.5G/close
The G-sensor is used to detect the 3-axis impacting forces. If any impact
over the threshold value is detected, the current recording file will be
locked/protected to avoid being over-written, and this is important in a
crash as you may become disoriented or not able to lock the file which has
recorded the incident. The level of sensitivity is set by selecting the
required amount of G Forces to cause the video to lock.
21.GPS:
on/off
After installing a GPS tracker correctly, start up the GPS function in menu
setting. When the icon appears on the main interface, it means that GPS
can be used normally. When the function has been started, all videos and
pictures recorded by the camera will contain GPS positioning and tracking
information, which can be shown on the computer by special software,
which can be downloaded via http://www.splashetech.net/.
