S o u n d P e r c u s s i o n L a b s . c o m
7
Hi-Hat Cymbal Stand Assembly
1.
Slide upper tube over the hi-hat pull rod and
into leg assembly. Tighten the wing nut at
desired height and secure Memory Lock.
Figure O.
2.
Place one hi-hat cymbal over the hi-hat rod
and onto the cymbal cup with the bottom
side of the cymbal facing up.
3.
Remove lower retaining nut and one rubber
washer from hi-hat clutch. Place the hi-hat
clutch through the top of the second hi-hat
cymbal, and reassemble the rubber washer
and retaining nut under the cymbal. The
cymbal should rest between the two rubber
washers. Figure P.
4.
Place the hi-hat clutch assembly and cymbal
onto the hi-hat rod. Tighten the wing nut
on the hi-hat clutch with the top cymbal
approximately one inch above the lower
cymbal. Stepping down on the hi-hat pedal
will engage the two cymbals. Figure Q.
NOTE: Adjust Bottom Tilter slightly to let air escape.
Hi-Hat
Pull Rod
Upper Tube
Leg Assembly
Close Up Of Hi-Hat Clutch Assembly
Figure O
Clutch
Lower Retaining Nut
Rubber Washers
Top hi-hat
cymbal
goes here
Figure P
Hi-hat clutch
and cymbal
assembly
Figure Q
Memory Lock
Wing Nut
Bottom Tilter
Cymbal Cup
