16
AMP CTL (Standby / Amplifier Control)
If you own an SPL device supporting AMP CTL output(s) you can trigger standby and
operation. Therefore connect the AMP CTL output of the SPL device with a mono mini
jack cable to the
AMP CTL (10)
of the Performer m1000.
You may also use other 12V trigger controller. The Performer m1000 is in operation
mode when a switching voltage of 12 Volt DC is applied to the AMP CTL input.
As soon as the 12 Volt DC is removed, the Performer m1000 switches back to
standby mode.
Use a mono mini jack cable where the tip is plus and the sleeve is minus.
Power LED
In standby the Power LED is dimly lit.
If the Performer m1000 is in operation, the Power LED lights up brightly.
If the Performer m1000 is off, e.g. the mains switch is off, the Power LED is off.
XLR WIRING:
Pin 1 = GND
Pin 2 = Hot (+)
Pin 3 = Cold (–)
Minimum Load:
2
Ω
INPUT
THRU
INPUT
TRIM
INP
UT
AMP CTL
/12
V TR
IG
GER
Connect to
AMP CTL output of
SPL Preamplifier/DAC
for remote power on/off
OR
Use 12 V Trigger
SPE
AK
ER
OUTP
UT
SPEAKER OUTPUT
+
–
AMP CTL/12V TRIGGER
0 -5.5
-5
-
4.5
-4
-3.5
-3
-2.
5
-
2
-1
.5
-
1
-
0.5
Tip
Sleeve
