H y d r a u l i c
R o t a r y H a m m e r D r i l l
2 2 4 1 8 0 0 1 0
M a s c h i n e n f a b r i k G m b H
Spitznas Maschinenfabrik GmbH, Fellerstr.4, D-42555 Velbert, Tel: +49(0)2052 605 0, Fax: +49(0)2052 605 29
, www.spitznas.de
Translation of the original operation
manual, compiled: 12.09.13
224180010_BA_en_Version_06
Page 9 of 11
OPERATING INSTRUCTION FOR UNDERWATER TOOLS
Before working under water
•
Check the machine with regard to leakages
•
Check the machine regarding functioning of all parts (drilling, striking, actuating valves, etc.)
•
Spraying of all moving parts with spray OKS 8604 (or similar).
•
Fitting the tools with grease.
After having worked under water
•
Clean the machine
•
Dry the machine by blowing out with compressed air
•
Spraying of all moving parts with spray OKS 8604 (or similar).
For additional information refer to the machine specific operation and maintenance manual as
well.
For a long lasting operation of the machine we recommend a regular (every 3 months) general
overhaul by the company SPITZNAS.
Spray OKS 8601: Spitznas-part no. 9 9902 0120
Maintenance Instruction
Good maintenance practice keeps the tool on the job and increases its service life.
The most important maintenance practice is to keep the hydraulic fluid clean at all times.
Contaminated fluid causes rapid wear and/ or failure of internal parts.
The proper quantity of grease is very important from the point of good lubrication and low heat
generation. The grease quantities listened in the following table must be complied with:
Grease
Quantity in grams
In the crank casing
5
In the bevel gear
5
In the spur gear
10
In the planetary gear
10
Grease SPITZNAS reference no. 9 9902 0130 (400 g), 9 9902 0250 (100 g)