P n e u m a t i c
C o r n e r D r i l l
2 1 7 0 1 0 0 0 0 / 0 0 1 0 / 0 0 3 0
M a s c h i n e n f a b r i k G m b H
Spitznas Maschinenfabrik GmbH, Fellerstr.4, D-42555 Velbert, Tel: +49(0)2052 605 0, Fax: +49(0)2052 605 29
, www.spitznas.de
Compiled: 21.01.10
21701000_0010_0030_en_Version_00.do
c
Page 12 of 22
Remove any oil and resin residue from the rotor slots. The new vanes item 50 should fit
easily into the slots. Insert cylinder bushing item 5 into the right side.
For the angular drive ensure the correct setting of the tooth engagement. Note the location
of the spacers. Use low viscosity grease (e.g. Calypsol D 6024) for the gearbox.
After completion of re-assembly make functional gauging by checking free speed (540 rpm)
and air consumption (1.4 m³/min). Mostly a check of the parameter for free speed and air
consumption is sufficient (see technical specification).
Spare Parts
Only original spare parts may be used. There is no warranty for damages and liability is
disclaimed, if non-original spare parts and accessories are used.
